About using Synergy Image Streamer in a single-frame configuration

A single HPE Synergy frame can be configured for development and testing of Image Streamer deployment plans and artifacts. The configuration, as a proof of concept, can demonstrate full management and deployment functionality.

A single-frame configuration must use an external deployment network and a single uplink port.

NOTE:

If HPE Virtual Connect SE 100Gb F32 Module for Synergy interconnect is used in single-frame, the deployment network mode can be set to Internal.

IMPORTANT:

A single-frame configuration is not highly available. If there is only one Image Streamer appliance, HPE OneView will issue an alert because two appliances are expected.

Software firmware in a single-frame configuration cannot be updated using available firmware update actions in the appliance. Instead the appliance must be reimaged to run a later software firmware release.

To change a single-frame configuration into a highly-available configuration, the single-frame configuration must be removed from HPE OneView (the logical enclosure is deleted) and recreated. The physical frame must be reconfigured. The artifacts stored on the Image Streamer appliance can be bundled and exported to the new highly-available configuration.

More information

About defining Image Streamer uplink sets in logical interconnect groups -- single frame configuration

HPE Synergy Image Streamer User Guide