Edit SNMP Settings
- SNMPv1 read community string
Credential applied to access data on managed and monitored devices that support SNMPv1 only.
- Add SNMPv3 User
- User name
Unique SNMPv3 user name. Each SNMPv3 user name is associated with a security level.
- Security Level
- None
- No security level set.
- Authentication
Requires an authentication protocol and passphrase.
- Authentication and privacy
Requires an authentication protocol and passphrase, and a privacy protocol and passphrase.
- Authentication Protocol
- MD5
Message Digest 5 (MD5) authentication protocol
- SHA1
Secure Hash Algorithm 1 (SHA1) authentication protocol
- SHA-256
Cryptographic hash function uses 256 bits.
- SHA-384
Cryptographic hash function uses 384 bits.
- SHA-512
Cryptographic hash function uses 512 bits.
- Authentication Passphrase
Authentication passphrase (minimum of 8 characters) associated with the SNMPv3 user.
- Privacy Protocol
- DES
Data Encryption Standard (DES) method of data encryption.
- 3DES
Triple Data Encryption Standard (3DES) method of data encryption applies the DES cipher algorithm three times to each data block.
- AES-128
Advanced Encryption Standard (AES) method of data encryption with a key size of 128 bits.
- AES-192
AES data encryption with a key size of 192 bits.
- AES-256
AES data encryption with a key size of 256 bits.
- Privacy Passphrase
Privacy passphrase (minimum of 8 characters) associated with the SNMPv3 user.
- Add Trap Destination
- Trap Destination
The IP address or host name of the SNMP manager to which traps are forwarded. Both IPv4 and IPv6 addresses are supported.
- Port
The port number, from 1 to 65535, configured at the destination receiving SNMP traps.
Default:
162
- Trap format
Format of traps:
SNMPv1
orSNMPv3
Setting the destination as an SNMPv1 trap, requires you also set the Community String.
Setting the destination as an SNMPv3 trap, requires you also set the SNMPv3 User name.
- Community String (SNMPv1)
The shared community name for authentication that serves as a password for a trap forwarding destination. This should match the community string of the destination.
- User name (SNMPv3)
SNMPv3 user name.