Enclosure configuration incomplete in HPE OneView

Symptom

An alert or error indicates that Enclosure management settings are not fully applied.

Cause

An add or refresh of an HPE Synergy frame failed and not all settings could be applied.

Action
  1. Follow the resolution instructions listed in the alert.

    If instructed to reset the frame link module, see reset the frame link module. Do not perform this step unless instructed.

  2. Review all alerts on the frame to check if other frame link modules or other hardware components are functioning properly. For each alert, follow the resolution instructions.
  3. Verify that each frame link module is properly seated and the health indicator light on the link module is green.
  4. Refresh the HPE Synergy frame .
  5. If the problem persists, contact your authorized support representative.