 |
| |
Modules can be installed in any order and in any combination and can hot swapped
Supported transceivers can be hot swapped.
The 5406R zl2 Switch has a routing/switching capacity of 496.8 Gbps, with a switch fabric speed of 561.6 Gbps and a throughput of 396 Mbps, and the 5412R zl2 Switch has a routing/switching capacity of 993.6 Gbps, with a switch fabric speed of 1123.2 Gbps and a throughput of 792 Mbps.
All ports are enabled. Just connect the network cables to active network devices and your switched network is operational.
Automatic learning of the network addresses in the switch’s 16,000-address forwarding table, with configurable address aging value.
Full-duplex operation available on all ports.
Easy management of the switch through several available interfaces:
Web browser interface: An easy to use built-in graphical interface that can be accessed from common web browsers.
Console interface: A full-featured, easy-to-use, VT-100 terminal interface for out-of-band switch management, or for TELNET access to the switch. The console includes complete switch management through a command line interface (CLI) and a slightly reduced feature set accessible through an intuitive menu interface.
Intelligent Management Center: A SOA-based HPE Network management application that accurately discovers and displays your switch on network maps and provides a graphical interface for configuring and monitoring your switch.
Support for the Spanning Tree Protocol to eliminate network loops.
Support for up to 2048 IEEE 802.1Q-compliant VLANs so you can divide the attached end nodes into logical groupings that fit your business needs.
Layer 3 routing functionality:
Static IP routing: Provides manually configured routing for both IPv4 and IPv6 networks.
OSPF: Provides OSPFv2 for IPv4 routing and OSPFv3 for IPv6 routing.
Routing Information Protocol (RIP): Provides RIPv1 and RIPv2 routing.
Policy-based routing: Uses a classifier to select traffic that can be forwarded based on policy set by the network administrator.
Border Gateway Protocol (BGP): Provides IPv4 Border Gateway Protocol routing, which is scalable, robust, and flexible.
Support for many other advanced features to enhance network performance, security, and control - for a description, see the Management and Configuration Guide on the HPE networking Web site at www.hpe.com/support/hpesc.
Support for IEEE 802.3af standard, IEEE 802.3at standard, and pre-standard PoE devices.
Supports dual management module capability.
Supports 100% PoE+ capacity at low line.
Supports existing v2 zl and v3 zl2 modules.
Support for three new power supplies:
BPSU (Base Power Supply unit - J9828A): Lower cost alternative.
LPSU (Low Power Supply unit - J9829A):
Dual-output 12V and 54V, with one C16 power receptacle.
For support of mid-range POE/POE+ installations.
HPSU (High Power Supply Unit - J9830A):
Dual-output 12V and 54V, with two C20 power receptacle.
Supports maximum POE/POE+ installations.
Support for Trusted Platform Module (TPM) subsystem for storing certificates and secure identity.
