Previous Topic

Next Topic

Cabling the chassis

After all system hardware is installed, cable the components.

WARNING: To reduce the risk of electric shock or injury due to high-current electrical energy, be sure that all power is completely disconnected at the source before beginning any power connections to the power bus bars or power bus box.

WARNING: Be sure that all circuit breakers are locked in the off position before connecting any power components.

CAUTION: To avoid damaging the fiber cables, do not drape cables from one side of the rack to the other and do not run cables over a hard corner or edge.

To cable the system:

  1. Connect the network cables to the Ethernet ports on the I/O module.
  2. Connect a network cable to the iLO connector on the management module.
  3. Connect the APM cable to the APM connector on the management module.