HPE P440ar/P840ar Flexible Smart Array Controller

CAUTION: Hewlett Packard Enterprise recommends performing a complete backup of all server data before performing a controller or adapter installation or removal.

Before installing the controller, you must observe the following requirements:

  • To ensure cables are connected correctly, observe the labels on the cable and component connectors.
  • Be sure you have the latest firmware for the controllers, HBAs, and the expander card. To download the latest firmware, see the Hewlett Packard Enterprise website.

To install the component:

Procedure
  1. Back up all server data.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Do one of the following:
  5. Remove the access panel.
  6. Remove the air baffle.
  7. Install the controller:
    • P440ar
      Installing an HPE Flexible Smart Array Controller
    • P840ar
      Installing a P840ar Flexible Smart Array Controller
  8. Connect the appropriate SAS cables. For more information, see Flexible Smart Array Controller cabling.
  9. Install the air baffle.
  10. Install the access panel.
  11. Do one of the following:
    1. Slide the server into the rack.
    2. Install the server into the rack.
  12. Connect each power cord to the server.
  13. Connect each power cord to the power source.
  14. Before powering on the system, be sure the HPE Smart Storage Battery is installed.
  15. Power up the server.