Install the SPI board

CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning any system installation. Improper grounding can cause electrostatic discharge.

To install the component:

1. Remove all power:
   1. Disconnect each power cord from the power source.
   2. Disconnect each power cord from the server.
2. Do one of the following:
   • Extend the server from the rack.
   • Remove the server from the rack.
3. Remove the access panel.
4. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use.
5. Extend the processor memory drawer approximately 2.54 to 5.1 cm (1 to 2 inches).

   

6. Connect the cables to the SPI board.

   

7. Install the SPI board and tighten the thumbscrews.

   

8. Install the processor memory drawer (Remove the processor memory drawer cover, Install the processor memory drawer).
9. Install the access panel.
10. Install the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server.