Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
-
Grasp the tray notch and extend the server tray out of the rack.
-
Place the server at the center of the server tray.
Align the front panel of the server with the edge of the tray.
-
Press and hold the blue rail-release tabs, and then slide the server tray back into the rack.
-
Tighten the server tray thumbscrews.
-
Connect all peripheral cables and power cords to the rear panel.
-
Secure the power cord with the strain relief strap. Roll the extra length of the strap around the power input module handle.
-
Connect each power cord to the power source.
-
Power up the server.
-
Enable the increased cooling function.
The installation is complete.