Install the access panel

Procedure

  1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the rear of the server approximately 1.25 cm (0.5 inch).
  2. Push down on the hood latch. The access panel slides to a closed position.
  3. Use a T-15 Torx screwdriver to tighten the security screw on the hood latch.
    Installing the access panel
  4. If the server is in a tower configuration, return the server to an upright position.
  5. If the server is in a rack configuration, slide the server into the rack.
  6. If a Kensington security cable was removed, connect it to the rear panel. See the security cable documentation for instructions.
  7. Connect each power cord to the server .
  8. Connect each power cord to the power source.
  9. Power up the server.
  10. Do one of the following:

Results