Physical Drive State: This physical drive is part of a logical drive that is not supported by the current configuration

Symptom

Physical Drive State: This physical drive is part of a logical drive that is not supported by the current configuration. Any configuration command (e.g. logical drive creation, array expansion, etc.) or modification to the controller will result in the loss of all existing data on the disabled logical drive(s).

Solution 1
Cause

The drive is not supported by the current configuration.

Action
If this message is observed after moving a configured array of drives from another controller, do the following:
  1. Upgrade the firmware on this controller.
  2. Verify that the cache module is installed. Install the cache module if not present.
  3. If the issue persists, power down the server and move the drives back to the original controller.
Solution 2
Action
If this message is observed without any drive movement, do the following:
  1. Verify that the cache module is installed. Install the cache module if not present.
  2. Verify that the cache module is working. Replace the cache module, if required.
  3. If the issue persists, contact Hewlett Packard Enterprise support.