Firmware flash log messages

Log type: LOG_ALERT, Failure type: SW

FWSync: OA firmware sync flash failed and system is in an unstable state. Do not reboot! Try to flash again with a new image.

OA_Flash: Flash failed and system is in an unstable state. Do not reboot!Try to flash again with a new image.

Log type: LOG_ERR, Failure type: SW

FWSync: Error opening OA firmware sync image.

FWSync: Error opening OA firmware sync image.

FWSync: Invalid flash image.

FWSync: OA firmware sync image is corrupted.

FWSync: OA firmware sync image is older than current firmware.

FWSync: Only one flash instance can run at a time.

FWSync: Only one instance of OA firmware sync can run at a time.

OA_Flash: Downloading flash image failed.

OA_Flash: Error opening [value] for input.

OA_Flash: Firmware image is corrupted or not a valid image. Please verify the url and try again.

OA_Flash: Firmware version [value:version] is not supported on this hardware.

OA_Flash: Found core file. Reboot after flash suppressed to allow developer to debug.

OA_Flash: Invalid flash image.

OA_Flash: Invalid flash image.

OA_Flash: Only one flash instance can run at a time.

OA_Flash: Out of memory while decoding flash image.

OA_Flash: The firmware image provided is older than the current firmware and OA settings cannot be preserved. The force downgrade option must be used. Please re-try with the force option to flash and go back to factory defaults.

Log type: LOG_NOTICE, Failure type: Info

FWSync: New firmware image flashed.

FWSync: OA firmware sync to [value:version] complete

OA_Flash: Firmware image flashed from [value:version] to [value:version]

Log type: LOG_INFO, Failure type: Info

OA_Flash: Image verified successfully and applies to this system using the parameters supplied. Test Mode specified, skipping the actual flash process Firmware version [value:version] ExitCode=0