Previous Topic

Next Topic

FlexibleLOM option

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the power cord to remove power from the server. The front panel Power On/Standby button does not completely shut off system power. Portions of the power supply and some internal circuitry remain active until AC power is removed.

  1. Power down the server.
  2. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  3. Remove any attached network cables.
  4. Extend the server from the rack.
  5. Remove the access panel.
  6. Loosen the thumbscrew.
  7. Remove the existing FlexibleLOM.

    Removing the adapter

To replace the component:

  1. Firmly seat the FlexibleLOM in the slot, and then tighten the thumbscrew.

    Installing the adapter

  2. Install the access panel.
  3. Slide the server into the rack.
  4. Connect the LAN segment cables.
  5. Connect each power cord to the server.
  6. Connect each power cord to the power source.
  7. Power up the server.