Universal media bay

1. Power down the server.
2. Remove all power:
   1. Disconnect each power cord from the power source.
   2. Disconnect each power cord from the server.
3. Extend the server from the rack.
4. Remove the access panel.
5. Remove the fan cage.
6. Depending on the server options installed, do one of the following:
   • Remove the air baffle.
   • Remove the mezzanine tray.
7. Disconnect the USB/VGA cables through the universal media bay opening, and then remove the universal media bay.

   

To replace the component:

1. Route the USB/VGA cables through the universal media bay opening, and then install the universal media bay.

   

2. Using the cable trough, connect the cable to the front VGA/USB 2.0 connector on the system board.

   

3. Depending on the server options installed, do one of the following:
   • Install the air baffle.
   • Install the mezzanine tray.
4. Install the fan cage.
5. Install the access panel.
6. Slide the server into the rack.
7. Connect each power cord to the server.
8. Connect each power cord to the power source.
9. Power up the server.