Previous Topic

Next Topic

DIMMs

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the power cord to remove power from the server. Pressing the Power On/Standby button does not shut off system power completely. Portions of the power supply and some internal circuitry remain active until AC power is removed.

IMPORTANT: This server does not support mixing RDIMMs and UDIMMs. Attempting to mix these two types causes the server to halt during BIOS initialization.

To identify the DIMMs installed in the server, see "DIMM slot locations."

To remove the component:

  1. Power down the server.
  2. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  3. Extend the server from the rack.
  4. Remove the access panel.
  5. Depending on the server options installed, do one of the following:
  6. Remove the DIMM.

    Removing a DIMM

To replace the component, reverse the removal procedure.

For DIMM configuration information, see the server user guide.