Previous Topic

Next Topic

Optical drive option

To install the component:

  1. Power down the server.
  2. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  3. Place the server on its side.
  4. Remove the access panel.
  5. Remove the front bezel.
  6. If installed, remove the PCI air baffle.
  7. Remove the system air baffle.
  8. Remove the optical drive cover.

    Removing the optical drive cover from the bezel

  9. Remove the EMI shield from the front panel

    Removing the EMI shield from the front panel

  10. Connect the cable to the rear of the drive and then route the cable through the drive bay.

    Connecting the optical disk drive cables

  11. Connect the power cable.
  12. Route the SATA cable underneath the metal tabs, and connect the opposite end of the cable to the connector on the system board.

    Connecting the SATA cables to the optical disk drive

  13. Install the system air baffle.
  14. If removed, install the PCI air baffle.
  15. Install the front bezel.
  16. Install the access panel.
  17. Return the server to an upright position.
  18. Connect each power cord to the server.
  19. Connect each power cord to the power source.
  20. Power up the server.