I/O board

When replacing the I/O board, be sure the system maintenance switch settings on the replacement board match the settings on the old board. For more information, see "System maintenance switch."

To remove the component:

1. Power down the server.
2. Remove all power:
   1. Disconnect each power cord from the power source.
   2. Disconnect each power cord from the server.
3. Extend the server from the rack.
4. Remove the access panel.
5. Extend the processor memory drawer approximately 2.54 to 5.1 cm (1 to 2 inches).

   

6. Remove the SPI board.
7. Remove the FlexibleLOM.
8. Remove any expansion boards installed on the I/O board.
9. Disconnect all cables connected to the I/O board.
10. Remove the I/O board.

    

To replace the component, reverse the removal procedure.