Removing and replacing a DIMM guard

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

Procedure
  1. If installed, remove the bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Do one of the following:
  5. Remove the access panel.
  6. If replacing the left DIMM guard, remove the chassis intrusion detection switch.
  7. Remove the DIMM guard.

    • Right DIMM guard


      Removing the right DIMM guard

    • Left DIMM guard


      Removing the left DIMM guard

To replace the component, reverse the removal procedure.