Removing and replacing the PDB or PDB cover

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

Procedure
  1. If installed, remove the bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source
    2. Disconnect each power cord from the server.
  4. Do one of the following:
  5. Remove the access panel.
  6. Remove all hot-plug power supplies.
  7. Disconnect the power and signal cables from the PDB.
  8. Remove the PDB.
    1. Remove the screws.
    2. Remove the PDB cover.
    3. Remove the PDB.


    Removing the PDB

To replace the component, reverse the removal procedure.