Module Status LED patterns during normal operation and Port link status LED patterns summarize LED color, and meaning, and any recommended user response.
The system and power LED patterns are shown in Module Status LED patterns during normal operation.
LED name | LED color | Status of hardware | Recommended action |
---|---|---|---|
Module Status | No light | Switch is off, boot is not complete, or boot failed. | Verify that switch is on and completed booting. |
Steady green | Switch is on and functioning. | No action required. | |
Flashing green (on 1 second, off 1 second) | One or both of the following
are true:
| Check environmental conditions, error log, Port Status LEDs, transceivers, cables, and loopback plugs. Correct error condition. Clear error log. Rerun diagnostics to verify fix. | |
Amber | Boot-up state; switch is disabled or offline. | Needs attention. |
Port link status LED patterns shows the LED color, meaning, and recommended action.
LED name | LED color | Status of hardware | Recommended action |
---|---|---|---|
Port Status | No light | Port is offline. No light or signal carrier (transceiver or cable) detected. | Check transceiver and cable. |
Steady green | Port is online (connected to external device) but has no traffic. | No action required. | |
Slow-flashing green (on 1 second, off 1 second) | Port is online but segmented, indicating a loopback cable or incompatible switch. | Verify the correct device is connected to port and the switch and port settings are correct. | |
Fast-flashing green (on 1/2 second, off 1/2 second) | Port is in internal loopback (diagnostic). | No action required. | |
Flickering green | Port is online with traffic flowing through port. | No action required. | |
Steady amber | Port is receiving light or signal carrier, but is not yet online. | No action required. | |
Slow-flashing amber (on 1 second, off 1 second) | Port is disabled as a result of diagnostics or portDisable command. If the LEDs for all ports are slow-flashing amber, the switch could be disabled. | Enable the port using the portEnable command; If the LEDs for all ports are slow-flashing amber, enable the switch by entering the switchEnable command. | |
Fast-flashing amber (on 1/2 second, off 1/2 second) | Port is faulty. | Check the Port Status LEDs, error log, transceiver, and cable or loopback plug. Clear the error log. Rerun the diagnostics to verify the error condition is fixed. |