HPE Synergy 4-Port Frame Link Module components and LEDs
HPE Synergy 4-Port Frame Link Modules require supported SFP+ DAC cables or SFP+ transceivers for cabling. For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website.
Item | Description | Function |
---|---|---|
1 |
MGMT port activity LED |
Reports MGMT port activity:
|
2 |
LINK port activity LED |
Reports LINK port activity:
|
3 |
KVM port |
NOTE:
Connection to the KVM port requires an HPE Synergy 4-Port Frame Link Module USB Adapter. NOTE:
Supports storage devices that are USB 2.0 compatible. When an
HPE Synergy 4-Port Frame Link Module USB Adapter is installed, the
HPE Synergy 4-Port Frame Link Module:
Used for performing a USB recovery frame link module firmware update. |
4 |
Appliance port 1 connectivity LED |
Reserved for future use. |
5 |
Appliance port 2 connectivity LED |
Reserved for future use. |
6 |
Appliance port 2 |
Reserved for future use. |
7 |
Appliance port 1 |
Reserved for future use. |
8 |
UID button / LED |
Toggles the UID LED on or off.
When turned on, the frame UID LED on the front panel also turns on. This synchronization allows identification of the frame from the front or rear. Do not remove either frame link module while the UID LED is flashing. |
9 |
USB adapter thumbscrew connection |
For securing an HPE Synergy 4-Port Frame Link Module USB Adapter to the HPE Synergy 4-Port Frame Link Module. |
10 |
Health LED |
Provides the health status of the frame link module.
|
11 |
LINK port |
SFP+ connector that provides the following functions: IMPORTANT:
Use supported SFP+ 10GbE DAC cables or transceivers for LINK port connections. For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website.
|
12 |
MGMT port |
SFP+ connector that provides the following functions: IMPORTANT:
Use supported SFP+ DAC cables or transceivers for MGMT port connections. For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website. IMPORTANT:
The transceiver or cable used must match the port speed of the switch used for management network connectivity.
|