Removing and replacing a DIMM

CAUTION:

Before replacing a DIMM, expansion board, or other similar PCA components due to a perceived hardware error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.

Procedure
  1. Remove the front bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Disconnect all peripheral cables from the server.
  5. Do one of the following:
  6. Remove the access panel.
  7. Remove the air baffle.
  8. If you are removing a DIMM for processor 2, and the fan cage is present, remove the fan cage.
  9. Remove the DIMM.

    Removing the DIMM

To replace the component, reverse the removal procedure.

For DIMM configuration information, see the Hewlett Packard Enterprise website.