CI Manager iLO SNMP traps Cold start Authentication failure The state of the processor in slot X is Y The appliance is operational again after thermal shutdown Power On Self Test (POST) errors occurred during appliance restart The appliance temperature is outside the normal operating range The appliance has been reset Remote Insight/Integrated Lights-Out self test error The appliance has been powered on The appliance has been powered off The appliance could not be powered on The iLO to Insight Remote Support or Insight Online communication failed Power threshold has been exceeded The disk drive status is X The overall condition of the processor subsystem is critical The overall condition of the processor subsystem is in the error state The condition of the memory subsystem is critical A temperature sensor is outside of normal operating range All temperature sensors are within normal operating range Hardware fault detected The overall status of the IDE disk subsystem is critical The overall status of the IDE disk subsystem is in the error state The appliance management processor condition is critical The appliance management processor condition is in error state The BIOS/Hardware status is critical The BIOS/Hardware is in the error state The BIOS status/Hardware is ok The appliance management processor condition is OK The overall status of the IDE disk subsystem is OK The overall condition of the processor subsystem is OK The memory subsystem is operating normally The appliance temperature has returned to the normal operating range