Installing the serial port

Prerequisites

Before you perform this procedure, make sure that you have the following items available:

The components included with the hardware option kit

Procedure
  1. Back up all server data.
  2. If installed, remove the bezel.
  3. Power down the server.
  4. Do one of the following:
    • Disconnect each power cord from the power source.
    • Disconnect each power cord from the server.
  5. Do one of the following:
  6. Remove the access panel.
  7. Remove the primary PCI riser cage.
  8. If installed, remove the expansion board from slot 3.

    Removing the expansion board from slot 3
  9. Remove the serial port blank. Retain the blank for future use.

    Removing the serial port blank
  10. Install the serial port and then install the screws.

    Install the serial port
  11. Install the access panel.
  12. Install the server in the rack.
  13. Connect each power cord to the server.
  14. Connect each power cord to the power source.
  15. Power up the server.
  16. If removed, install the bezel.