Installing an LFF drive To add internal data storage to the server, install one or more LFF drives in the drive bays. Procedure Power down the server. Disconnect the power cord from the AC source, and then from the server. Disconnect all peripheral cables from the server. Remove the front bezel. Install the LFF drive. Install the front bezel. Connect all peripheral cables to the server. Connect the power cord to the server power jack, and then to the AC source. Power up the server. Determine the status of the server drives from the drive LED definitions. To configure drive arrays, do one of the following: If the drives are connected to the onboard LFF/SFF drive SATA port, use the Marvell Storage Utility or the Marvell BIOS Utility. If the drives are connected to a Smart Array storage controller board, use the HPE Smart Storage Administrator. Install the LFF drive