The
system supports optional PCIe cards.
IMPORTANT: The PCIe card is not hot-pluggable. The
system must be powered down to install this card.
Procedure
-
Power down the system.
-
Remove the cartridge, if installed.
-
Remove the access panel.
-
Using a Torx driver, remove the three black T-15 Torx screws.
-
Lift the PCIe riser cage using the finger hold positions in the riser cage.
-
Disconnect the power cable.
-
Disconnect the hard drive backplane cable and any other cables that connect to the PCIe cards.
-
Align the PCIe card to the PCIe slot on the side of the system, and then slide it in until it clicks in place.