Removing and replacing the secondary riser slot 3 transfer board

CAUTION:

Before replacing a DIMM, expansion board, or other similar PCA components due to a perceived hardware error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.

Prerequisites

Before you perform this procedure, make sure that you have thea T-10 and T-15 Torx screwdrivers available.

Procedure
  1. Power down the server.
  2. Disconnect all peripheral cables from the server.
  3. Remove the server from the chassis.
  4. Remove the bayonet board.
  5. Remove the three-slot secondary riser cage.
  6. If an expansion board is installed, do the following:
    1. Remove the side bracket.
    2. Disconnect all cables from the expansion board.
    3. Remove the expansion board.

      Removing an expansion board from the secondary riser slot 3 transfer board
  7. Remove the secondary riser slot 3 transfer board.

    Removing the secondary riser 3 transfer board

To replace the component, reverse the removal procedure.