Removing and replacing a bayonet board

CAUTION:

Before replacing a DIMM, expansion board, or other similar PCA components due to a perceived hardware error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.

Prerequisites

Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.

Procedure
  1. Power down the server.
  2. Disconnect all peripheral cables from the server.
  3. Remove the server from the chassis.
  4. Remove the bayonet board.
  5. Separate the small bayonet boards from the large bayonet board.

    Separating the small bayonet boards from the large bayonet board

To replace the component, reverse the removal procedure.

NOTE:

Two units must be purchased when placing an order for the small bayonet board. For more information, see Bayonet board spare parts.