Install the bayonet board

Prerequisites

Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.

Procedure
  1. Install the bayonet board:
    1. Connect all the bayonet board cables.
    2. Install the bayonet board. Make sure that the board is firmly seated in the connector.

      Installing the bayonet board
    3. Install the bayonet board cover, and then install the screws to secure it to the server tray.
      CAUTION:

      To avoid physical damage to the chassis, do not carry/handle the server tray from the location where the bayonet assembly is installed.


      Installing the bayonet board cover and the screws securing the board to the server tray
    4. Install the screws to secure the cover to the bayonet board.

      Installing the screws securing the cover to the bayonet board
  2. Install the server into the chassis.
    CAUTION:

    Do not use excessive force while installing the server.

  3. Connect all peripheral cables to the server.
  4. Power up the server.