Remove the bayonet board

Prerequisites

Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.

Procedure
  1. Power down the server.
  2. Disconnect all peripheral cables from the server.
  3. Remove the server from the chassis.
    CAUTION:

    Do not use excessive force while removing the server.

  4. Remove the bayonet board:
    1. Remove the screws securing the cover to the bayonet board.

      Removing the screws securing the cover to the bayonet board.
    2. Remove the screws securing the cover to the server tray, and then remove the cover.
      CAUTION:

      To avoid physical damage to the chassis, do not carry/handle the server tray from the location where the bayonet assembly is installed.


      Removing the bayonet board cover
    3. Disconnect the bayonet board cables, and then remove the bayonet board.

      Removing the bayonet board