Removing and replacing an HPE Persistent Memory module

For specific population and configuration information, see the memory population guidelines on the Hewlett Packard Enterprise website (http://www.hpe.com/docs/memory-population-rules).

To identify the HPE Persistent Memory modules installed in the server, see HPE Persistent Memory module label identification.

Procedure

Observe the following alerts:
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you are properly grounded before beginning this procedure.

CAUTION:
Failure to properly handle HPE Persistent Memory modules can damage the component and the system board connector.
Power down the server (Power down the server).
Remove all power:
1. Disconnect each power cord from the power source.
2. Disconnect each power cord from the server.
Do one of the following:
- Extend the server from the rack (Extend the server from the rack).
- Remove the server from the rack (Remove the server from the rack).
Place the server on a flat, level work surface.
Remove the access panel.
Do one of the following:
- Remove the air baffle (Removing the air baffle).
- Remove the 4 LFF midplane cage (Removing and replacing a 4 LFF midplane cage).
Remove the HPE Persistent Memory module.
Install the new HPE Persistent Memory module, and review the persistent memory configuration of the server.
For more information, see Configuring the server for HPE Persistent Memory.
If you are relocating the HPE Persistent Memory module to or from another server, see the HPE Persistent Memory module relocation guidelines.

To replace the component, reverse the removal procedure.