Removing and replacing a rear serial port interface (tertiary riser)

1. Power down the server (Power down the server).
2. Remove all power:
   1. Disconnect each power cord from the power source.
   2. Disconnect each power cord from the server.
3. Do one of the following:
   • Extend the server from the rack (Extend the server from the rack).
   • Remove the server from the rack (Remove the server from the rack).
4. Remove the access panel (Remove the access panel).
5. Disconnect the cable.
6. Remove the tertiary riser cage.
7. Using a T-10 Torx screwdriver, remove the serial port interface.

   

To replace the component:

8. Install the serial port interface.
9. Connect the cable.
10. Install the riser.