Installing the Chassis Intrusion Detection switch
Procedure
- If installed, remove the front bezel.
- Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
- Disconnect all peripheral cables from the server.
- Remove the server from the rack.
- Remove the access panel.
-
Install the chassis intrusion detection switch on the DIMM guard and
connect the cable to the system board.
- Install the access panel.
- Install the server into the rack.
- Connect all peripheral cables to the server.
-
Connect the power cords:
- Connect each power cord to the server.
- Connect each power cord to the power source.
- Power up the server.
- If removed, install the front bezel.
The installation is complete.