Front panel LEDs and buttons

Item	Description	Status
1	Health LED	Solid green = Normal Flashing green (1 flash per sec) = iLO is rebooting Flashing amber = System degraded^[2] Flashing red (1 flash per sec) = System critical²
2	NIC status LED¹	Solid green = Link to network Flashing green (1 flash per second) = Network active Off = No network activity
3	Front drive health/thermal LED	Solid green = Drives supported by the SAS expander are functional.^[3] Solid amber = Failure or predictive failure of one or more drives supported by the SAS expander.³ Flashing amber (1 flash per sec) = The temperature sensor in one or more front drives is about to reach the thermal threshold. Immediately slide the front drive cages back into the chassis and keep them there until the LED turns green.^[4] Off = No power present^[5]
4	Power On/Standby button and system power LED¹	Solid green = System on Flashing green (1 flash per second) = Performing power on sequence Solid amber = System in standby Off = No power present⁵
5	UID button/LED¹	Solid blue = Activated Flashing blue: 1 flash per second = Remote management or firmware upgrade in progress 4 flashes per second = iLO manual reboot sequence initiated 8 flashes per second = iLO manual reboot sequence in progress Off = Deactivated

^[1] When these four LEDs flash simultaneously, a power fault has occurred. For more information, see Power fault LEDs.

^[2] If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.

^[3] This LED behavior applies to all front drives, as well as to the rear drives connected to the front drive cage 2 backplane.

^[4] This LED behavior depends on the iLO 08-HD Max sensor reading. For more information, see Front drive thermal LED.

^[5] Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the front I/O cable is disconnected.