Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Flat-headed screwdriver
T-10 Torx screwdriver
Procedure
-
If installed,
remove the front bezel.
-
Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
-
Do one of the following:
-
Remove LFF partition.
- Use the flat-headed screwdriver and carefully pry the two box 1 fillers.
- Remove two T-10 screws.
- Lift the top cover upward slightly and pull out the partition.
To replace the component, reverse the removal procedure.