Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
Procedure
-
If installed,
remove the front bezel.
-
Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
-
Do one of the following:
-
Remove the access panel.
-
Remove the air baffle.
-
Disconnect the iLO Service Port cable from system board.
-
Do one of the following:
-
SFF
Remove the SFF Front IO cage.
![Removing SFF Front I/O cage](hur_155.png)
Remove the iLO Service Port cable assembly.
![Removing iLO service port assembly](hur_147.png)
To replace the component, reverse the removal procedure.