Removing and replacing an expansion board

Prerequisites

Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.

Procedure
  1. Power down the server.
  2. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  3. Do one of the following:
  4. Remove the access panel.
  5. Disconnect any internal cables that are connected to the expansion board.
  6. Remove the riser cage.
  7. Remove the expansion board:

    • Primary riser cage


      Removing the expansion board

    • Secondary riser cage

      • Slot 4


        Removing the expansion board

      • Slot 5 or 6


        Removing the expansion board

    To replace the component, reverse the removal procedure.