Removing and replacing a Smart Array type-a modular controller

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

Procedure
  1. If installed, remove the front bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Do one of the following:
  5. Remove the access panel.
  6. If installed, remove the secondary riser cage.
  7. Disconnect all cables from the storage controller.
  8. Remove the storage controller.

    Removing the storage controller

To replace the component, reverse the removal procedure.