Removing and replacing an M.2 SSD

Prerequisites

Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.

Procedure

Power down the server.
Remove all power:
1. Disconnect each power cord from the power source.
2. Disconnect each power cord from the server.
Do one of the following:
- Extend the server from the rack.
- Remove the server from the rack.
Remove the access panel.
Disconnect SATA cables from system board.
Remove the riser cage.
Remove the M.2 SSD enablement board.
Remove the M.2 SSD.

To replace the component, reverse the removal procedure.