Removing and replacing the iLO Service Port assembly in SFF

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

Procedure

If installed, remove the bezel.
Power down the server.
Remove all power:
1. Disconnect each power cord from the power source
2. Disconnect each power cord from the server.
Do one of the following:
- Extend the server from the rack.
- Remove the server from the rack.
Remove the access panel.
Remove the SFF front I/O assembly.
Remove the iLO Service Port assembly in SFF.
1. Remove one T-15 screw.
2. Remove the iLO Service Port assembly.

To replace the component, reverse the removal procedure.