Removing and replacing the iLO Service Port assembly in LFF

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

Procedure

If installed, remove the bezel.
Power down the server.
Remove all power:
1. Disconnect each power cord from the power source.
2. Disconnect each power cord from the server.
Do one of the following:
- Extend the server from the rack.
- Remove the server from the rack.
Remove the access panel.
Disconnect the iLO Service Port cable from the system board.
Release the cable from clips.
Remove the iLO Service Port assembly in LFF:
1. Remove one T-15 screw.
2. Remove the iLO Service Port assembly.

To replace the component, reverse the removal procedure.