Removing the server from the rack

WARNING: This server is heavy. To reduce the risk of personal injury or damage to the equipment:

  • Observe local occupational health and safety requirements and guidelines for manual material handling.

  • Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened to the rails.

    Hewlett Packard Enterprise recommends that a minimum of two people are required for all rack server installations. If the server is installed higher than chest level, a third person may be required to help align the server.

  • Use caution when installing the server in or removing the server from the rack. The server is unstable when not fastened to the rails.

Procedure
  1. If installed, remove the bezel.
  2. Power down the server.
  3. Extend the server from the rack.
  4. Remove the server from the rack. Press and hold both server rail-release latches while removing the server.



  5. Place the server on a sturdy, level surface.