Removing and replacing the chassis intrusion detection switch

Procedure

If installed, remove the front bezel.
Power down the server.
Remove all power:
1. Disconnect each power cord from the power source.
2. Disconnect each power cord from the server.
Do one of the following:
- Extend the server from the rack.
- Remove the server from the rack.
Remove the access panel.
Disconnect the chassis intrusion detection switch cable from the system board.
Remove the chassis intrusion detection switch.
1. Release the cable from the left DIMM guard.
2. Detach the switch from the left DIMM guard.

To replace the component, reverse the removal procedure.