Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
-
Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
-
Disconnect all peripheral cables from the server.
-
Do one of the following:
-
Remove the access panel.
-
Remove the riser cage.
-
Remove the existing riser board.
-
Mount the riser board with the guiding pins on the riser cage, and then install the screws.
Primary riser cage
Secondary riser cage
-
If installing the expansion board,
do it now.
-
Install the riser cage.
-
Install the access panel.
-
Install the server into the rack.
-
Connect all peripheral cables to the server.
-
Connect each power cord to the server.
-
Connect each power cord to the power source.
-
Power up the server.
The installation is complete.