Installing a fan

Procedure
  1. If installed, remove the front bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Disconnect all peripheral cables from the server.
  5. Do one of the following:
  6. Remove the access panel.
  7. Remove the air baffle.
  8. Determine which fan blanks need to be removed to install the additional fans.
  9. Remove the fan blank.

    Removing the fan blank
  10. Install the fan:
    1. Install the fan into the fan cage.
    2. Route the fan cable through the groove on the fan cage.
    3. Connect the fan cable to the system board.

    Installing the fan
  11. Install the air baffle.
  12. Install the access panel.
  13. Install the server into the rack.
  14. Connect all peripheral cables to the server.
  15. Connect each power cord to the server.
  16. Connect each power cord to the power source.
  17. Power up the server.
  18. If removed, install the front bezel.

The installation is complete.