Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
-
If installed,
remove the front bezel.
-
Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
-
Disconnect all peripheral cables from the server.
-
Do one of the following:
-
Remove the access panel.
-
Remove the primary riser cage.
-
Remove the Media Module adapter blank.
-
Install the Media Module adapter:
- Align the Media Module adapter to the opening on the rear panel.
- Press the other end of the Media Module adapter down to connect on the system board.
- Firmly seat the Media Module adapter in the connector and ensure that it is secured with the latch.
- Install the Media Module adapter screws.
-
Install the primary riser cage.
-
Install the access panel.
-
Install the server into the rack.
-
Connect all peripheral cables to the server.
-
Connect each power cord to the server.
-
Connect each power cord to the power source.
-
Power up the server.
-
If removed,
install the front bezel.
The installation is complete.