Installing the optical drive in the LFF chassis

Prerequisites

Before you perform this procedure, make sure that you have the following items available:

  • T-10 Torx screwdriver

  • T-15 Torx screwdriver

Procedure
  1. If installed, remove the front bezel.
  2. Power down the server.
  3. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the server.
  4. Disconnect all peripheral cables from the server.
  5. Do one of the following:
  6. Remove the access panel.
  7. Remove the air baffle.
  8. Disconnect the iLO service port cable from system board.
  9. Remove the optical drive cage.

    Removing the ODD cage
  10. Install the optical drive:
    1. Remove the optical drive blank.

      Removing the ODD blank
    2. Install the optical drive into cage.

      Installing the ODD
    3. Install the optical drive cage into the box 1.

      Installing the ODD cage
    4. Connect the optical drive cable.
  11. Connect the iLO service port cable to system board.
  12. Install the air baffle.
  13. Install the access panel.
  14. Install the server into the rack.
  15. Connect all peripheral cables to the server.
  16. Connect each power cord to the server.
  17. Connect each power cord to the power source.
  18. Power up the server.
  19. If removed, install the front bezel.

The installation is complete.