Prerequisites
Before you perform this procedure, make sure that you have a hex nut screwdriver available.
Procedure
-
If installed,
remove the front bezel.
-
Power down the server.
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
-
Disconnect all peripheral cables from the server.
-
Remove the serial port blank from rear panel.
-
Install the serial port:
- Insert the serial port on the rear panel.
- Install the screws.
- Connect the serial port cable to the system board.
-
Install the access panel.
-
Install the server into the rack.
-
Connect all peripheral cables to the server.
-
Connect each power cord to the server.
-
Connect each power cord to the power source.
-
Power up the server.
-
If removed,
install the front bezel.
The installation is complete.