Installing two-bay SFF hot-plug rear drive cage

Prerequisites

Before you perform this procedure, make sure that you have the following items available:

  • The components included with the hardware kit

  • Torx T-15 screwdriver

Procedure
  1. Power down the system (Power down the system).
  2. Remove all power:
    1. Disconnect each power cord from the power source.
    2. Disconnect each power cord from the system.
  3. Remove the system from the rack (Remove the system from the rack).
  4. Place the system on a flat, level work surface.
  5. Remove the access panel (Remove the access panel).
  6. Remove the air baffle (Remove the air baffle).
  7. Remove the rear option blank (Remove the rear drive cage blank).
  8. Install the two-bay SFF rear drive cage:

  9. Connect the cables depending on your system configuration (Rear SFF drive cage cabling).
  10. Install the air baffle (Install the air baffle ).
  11. Install the access panel (Install the access panel).
  12. Install the system into the rack (Installing the system into the rack).
  13. Power up the system (Power up the system).