HPE Virtual Connect SE 40Gb F8 Module for HPE Synergy LEDs and buttons

Item	Description	Status
1	Interconnect link port LEDs	Solid green = Linked Solid red = Error detected¹. Off = No link
2	QSFP+ port LEDs	The four LEDs above each port correspond to the 10GbE or 8Gb FC channels of the port. The LEDs display one of four modes: Ethernet mode: Solid green = The port is configured as an Ethernet port. Off = The port is not configured as an Ethernet port. PID mode: Solid green = The port is configured as an uplink port. Solid amber = The port is configured as a stacking port. Solid purple = The port is configured as a mirrored port. Solid red = Error. Solid blue = Activated by OneView for port identification. Off = The port is not configured. Link/Activity mode: Solid green = 10Gb Ethernet link Flashing green = 10Gb Ethernet activity Solid amber = 8Gb FC link Flashing amber = 8Gb FC activity Solid purple = 40Gb Ethernet link Flashing purple = 40Gb Ethernet activity Solid Red = Error Off = No link Fibre Channel (FC) mode: Solid green = The port is configured as an FC port. Off = The port is not configured as an FC port. To switch between the LED modes, press the NEXT button.
3	NEXT button	Selects the QSFP+ port LED mode.
4	Reset pin-hole	Resets the module
5	UID LED/button	Solid blue = Activated Flashing blue = Firmware upgrade in progress Off = Deactivated
6	Health LED	Solid green = Normal Solid amber = No power present Flashing amber = Module degraded Solid red = A physical alignment error exists.²
7	Link/Activity mode LED³	Solid green = Link/Activity mode is selected.
8	PID mode LED³	Solid green = PID mode is selected.
9	Ethernet mode LED³	Solid green = Ethernet mode is selected.
10	Fibre Channel (FC) mode LED³	Solid green = FC mode is selected.

¹

See OneView (

http://www.hpe.com/info/oneview/docs

)

²

Remove and then reinstall the module.

³

When illuminated, QSFP+ port LEDs indicate the port operating states for each of the uplink ports in the selected mode.