Configuration overview

Prerequisites
Before you begin configuring the frame, you should have completed the following steps:

  • Installed the frame into the rack.

  • Installed all components into the frame.

  • Completed the HPE Synergy cabling required for your configuration.

Procedure
  1. Setup the management network.
    1. Connect to the HPE Synergy Console.
    2. Run hardware setup.
    3. Remotely connect to HPE OneView.
    4. Configure the Network Time Protocol.
    5. Add the IP and subnet address ranges.
  2. Configure the hardware in HPE OneView.
    1. Create a network.
    2. Create a logical interconnect group.
    3. Define an enclosure group.
    4. Create a logical enclosure.
    5. Create a server profile.
  3. Update the firmware.
    1. Update the HPE Synergy appliance module firmware.
    2. Add a firmware bundle to the appliance module firmware repository.
  4. Configure HPE Synergy Image Streamer.

    For more information, see "Quick Start: Initial configuration of HPE Synergy Image Streamer" in the HPE OneView Help for HPE Synergy at http://www.hpe.com/info/synergy-docs.

  5. Configure additional settings.

    For more information, see "Quick Start: Initial configuration of HPE OneView" in the HPE OneView Help for HPE Synergy at http://www.hpe.com/info/synergy-docs.